Owner Resources

Spray Foam Warranty: Manufacturer Terms vs Your Workmanship

An applicator in a blue coverall, goggles and respirator spraying foam insulation onto a framed wall

A spray foam job carries separate promises from separate parties. The manufacturer’s written warranty speaks for the foam, on conditions it sets out. Your workmanship promise covers how the foam went in, and it is yours to write and to honor. Your liability policy stands behind the business, and it is not a warranty.

What the foam maker’s warranty actually promises

The manufacturer warranties read for this guide pay for material, not for your crew’s time. A manufacturer’s published limited warranty for its wall foam warrants the products “to be free of defects in material at time of sale and to meet published physical properties when applied, cured and tested in accordance with” its published application specifications. Another manufacturer’s limited lifetime warranty for closed-cell foam says the foam, “when installed by authorized contractors using trained applicators and applied in accordance to the product specification, will perform as stated in the Product Technical Data Sheet.”

The remedy is narrow in each document. The closed-cell warranty says the maker’s “sole responsibility under this Limited Lifetime Warranty shall be to repair or replace any defective Product at the cost of the material only.” It adds that the maker “shall not be responsible for labor cost or any other costs whatsoever related to, or in connection with, the removal or installation of either the original or replacement product.” The wall foam warranty leaves out labor too. Cutting out and respraying foam is labor, which your own promise fills or leaves open.

The conditions printed in the product warranty

A product warranty comes with conditions, and the installation is where the documents read here put them. The wall foam warranty states that its products “must be installed in strict compliance with the applicable” application specification and written instructions. The closed-cell warranty says the maker is not liable under it for “defects or failure caused by improper installation of Product” that is not in strict adherence with its written instructions.

Registration and notice are conditions too. The closed-cell warranty says “This warranty is in effect throughout the life of the building provided the original purchaser registers with the Warranty Department” of the maker within a period the document sets. Owners claiming under it give written notice “of the defect promptly following its discovery” and must submit “proof of the date of purchase, contractor who applied the Product and the date, location and description of the circumstances under which the defect occurred or was first noticed.” Hand the owner the manufacturer’s warranty at closeout, point out any registration step, and keep a copy in your job file: the proof it asks for names you.

Your workmanship promise is a different document

The promise about how the foam went in comes from you, not from the foam maker. The closed-cell warranty says “Statements made by contractors and installers about the performance qualities of the Product or contained in advertising literature do not constitute an expressed warranty.”

Your own words can still matter under the federal warranty law. The FTC’s interpretation of the warranty rules says a supplier who only resells a product under another business’s written warranty is not liable for that warranty’s failure to comply, but “other actions and written and oral representations of such a supplier in connection with the offer or sale of a warranted product may obligate that supplier under the Act.” It tells suppliers to consult state law on what “may make them co-warrantors”.

How far Magnuson-Moss reaches an insulation job

The federal warranty law reaches written warranties on consumer products, and whether foam in a house counts turns on the transaction. The Magnuson-Moss Warranty Act defines a consumer product as tangible personal property “normally used for personal, family, or household purposes (including any such property intended to be attached to or installed in any real property without regard to whether it is so attached or installed).” A written warranty, under the same Act, includes a promise that material or workmanship “is defect free or will meet a specified level of performance over a specified period of time”.

The FTC’s interpretation of the Act’s coverage of building materials says “The coverage of building materials which are not separate items of equipment is based on the nature of the purchase transaction.” It treats such materials as consumer products “where a consumer contracts for the purchase of such materials in connection with the improvement, repair, or modification of a home (for example, paneling, dropped ceilings, siding, roofing, storm windows, remodeling)”, but not where they are “at the time of sale integrated into the structure of a dwelling”. The FTC’s examples do not name insulation, and this guide draws no conclusion from them for a given job.

Services and commercial work have their own lines. Writing about repairs to consumer products, the same interpretation says “warranties on services are not covered” and “warranties which apply solely to a repairer’s workmanship in performing repairs are not subject to the Act.” That paragraph speaks to repairs, so get legal advice before you lean on it for an installation warranty. The FTC’s disclosure rule says “Products which are purchased solely for commercial or industrial use are excluded solely for purposes of this part.”

Writing a workmanship warranty you can keep

Put your workmanship promise in writing, give it a defined term, and say plainly what you will do and what you will not. Where the disclosure rule binds a warrantor, it lists what the warranty must disclose, and the same items can outline yours. The list includes “A statement of what the warrantor will do in the event of a defect, malfunction or failure to conform with the written warranty, including the items or services the warrantor will pay for or provide”, and “The point in time or event on which the warranty term commences, if different from the purchase date, and the time period or other measurement of warranty duration”.

Some wording is off limits for a warrantor under the Act: the FTC’s interpretation on a warrantor’s decision as final says a warrantor “shall not indicate in any written warranty or service contract either directly or indirectly” that its decision “is final or binding in any dispute concerning the warranty or service contract.”

The warranty sits inside a contract, and the contract’s other terms reach your insurance. Our guide to bidding insulation jobs takes up the scope, the exclusions and those terms.

Maine’s home construction contract: a warranty statement written into the statute

A state’s contract statute can supply warranty language of its own, and Maine’s does. Its home construction contracts statute lists a warranty statement among the parts a covered home construction contract must contain. The statement opens “In addition to any additional warranties agreed to by the parties” and says “the contractor warrants that the work will be free from faulty materials; constructed according to the standards of the building code applicable for this location; constructed in a skillful manner and fit for habitation or appropriate use.”

Under the same statute, the contract must also carry, “If the construction includes installation of insulation in an existing residence, any disclosures required by chapter 219” of Maine’s statutes, the chapter on insulation contractors. The statute sets its own scope, and the Maine page reads it beside the insulation contractors chapter. Working in another state, start with that state’s page before you write your warranty.

Fact sheets and the R-value receipt as warranty paperwork

The FTC’s R-value rule already makes an installer of home insulation hand over paperwork, and that paperwork is the dated statement of what you installed. Before the sale, the R-value rule says “Before customers agree to buy insulation from you, you must show them the fact sheet(s) for the type(s) of insulation they want.” After the job, the same rule says “If you are an installer, you must give your customers a contract or receipt for the insulation you install.” For insulation other than loose-fill and reflective, “the receipt must show the coverage area, thickness, and R-value of the insulation you installed.”, and “The receipt must be dated and signed by the installer.” For loose-fill insulation, the receipt adds the initial installed thickness, the minimum settled thickness and how many bags went in. Our fiberglass, blown-in and cellulose page covers those crews. The license guide puts the receipt beside the licensing question.

Callbacks: fixing the work or reporting a claim

Before you send a crew back, sort out what the callback is: a repair under your own promise, damage your liability policy may answer for, or a blend of them. The ISO form as the County of Sonoma publishes its sample copy says “We will pay those sums that the insured becomes legally obligated to pay as damages because of ‘bodily injury’ or ‘property damage’ to which this insurance applies.” It adds “No other obligation or liability to pay sums or perform acts or services is covered unless explicitly provided for under Supplementary Payments – Coverages A and B.” Read with your warranty in mind, the form pays damages the business owes; it does not take over your promise to come back and do the work.

The exclusions follow the same line. Exclusion j removes “That particular part of any property that must be restored, repaired or replaced because ‘your work’ was incorrectly performed on it.”, though the form carves out property damage that falls within the products-completed operations hazard. Exclusion l removes “‘Property damage’ to ‘your work’ arising out of it or any part of it” once the work falls within that hazard, with an exception where a subcontractor performed the work on your behalf.

Know this condition before you pay for anyone else’s repair: “No insured will, except at that insured’s own cost, voluntarily make a payment, assume any obligation, or incur any expense, other than for first aid, without our consent.” The form also says “You must see to it that we are notified as soon as practicable of an ‘occurrence’ or an offense which may result in a claim.” When a callback turns up damage beyond your own foam, report it to your insurer before you agree to pay for someone else’s repair; your policy’s own wording decides the claim.

Real-World Scenario: A homeowner calls the owner of a closed-cell crew after a stain shows up on a bedroom ceiling below an attic the crew sprayed months earlier. Before sending anyone, the owner pulls the signed receipt, the manufacturer’s warranty and the job photos. He calls his insurance agent the same day, because the ceiling belongs to the customer, and the crew inspects the foam while the notice goes in.

The pricing guide builds a callback reserve into the method.

Completed operations: the coverage behind finished foam

In the standard form, completed operations means the products-completed operations hazard, and injury or damage from finished work can fall inside it; a warranty problem that hurts someone or damages other property may be a claim to report. The hazard “Includes all ‘bodily injury’ and ‘property damage’ occurring away from premises you own or rent and arising out of ‘your product’ or ‘your work’”, and the form excepts “Products that are still in your physical possession” and “Work that has not yet been completed or abandoned”.

The definition also says “Work that may need service, maintenance, correction, repair or replacement, but which is otherwise complete, will be treated as completed.”

Your warranty sits inside that picture. The form’s definition of “your work” includes “Warranties or representations made at any time with respect to the fitness, quality, durability, performance or use of ‘your work’”. Whether a given callback is covered still turns on the insuring agreement and the exclusions above.

The hazard has its own limit: the Products-Completed Operations Aggregate Limit “is the most we will pay under Coverage A for damages because of ‘bodily injury’ and ‘property damage’ included in the” hazard. Among its other conditions, the insuring agreement reaches injury or damage only when it “occurs during the policy period”.

Our general liability page reads the standard form’s exclusions and its completed operations hazard against insulation jobs, and the spray foam insurance page is written for foam crews. Buying a foam company raises the same question about the seller’s finished jobs, and our guide for buyers takes it up.

What to keep in the job file

Keep the paper that answers a callback before the call comes. For each job, that means the fact sheet you showed before the sale, the dated and signed receipt, the manufacturer’s warranty with any registration step the owner completed, your written workmanship warranty with its term and claim steps, the contract with its insurance terms, and the date you gave your insurer notice of any damage.

When you are ready to quote, tell us how you write your workmanship warranty and whether subcontractors do any of the work; the quote form is where that starts, and the overview of insulation business insurance lays out the full set of coverages.

The promises and the coverage behind a spray foam job, from the foam maker’s warranty to completed operations

A comparison of promises and coverage. On the promise side sit the manufacturer’s product warranty, which speaks for the foam on the maker’s conditions and leaves labor out in the warranties read for this guide; the installer’s own workmanship promise; the federal and state warranty rules, where the federal rules reach building materials by the nature of the purchase transaction and a state statute may add its own wording; and the job file that shows what was promised and installed. On the coverage side sit general liability, which pays damages the business has a legal duty to pay, under its terms, and is not a warranty, and completed operations, which in the standard form can take in injury or damage from jobs already done. No figures are shown.

Frequently asked questions

Spray foam warranty: who stands behind the foam, and who stands behind the install?

In the manufacturer warranties read for this guide, the maker stands behind the product on its own written terms, and the installation is the installer’s to promise. A closed-cell warranty says “Statements made by contractors and installers about the performance qualities of the Product or contained in advertising literature do not constitute an expressed warranty.” Those documents pay for material, not labor, so a written workmanship promise, with its own term and claim steps, fills the space they leave.

Spray foam insulation warranty: does the manufacturer pay for labor?

Not under the manufacturer warranties read for this guide. A closed-cell warranty says the maker’s “sole responsibility under this Limited Lifetime Warranty shall be to repair or replace any defective Product at the cost of the material only.” A wall foam warranty says “The warranty does not cover any labor costs for inspection, testing or repair” of its foam. Other makers write their own terms, so read the warranty for the product you spray and tell the customer what it leaves out.

Closed cell spray foam warranty: what does the manufacturer require?

The closed-cell warranty read for this guide says the foam, “when installed by authorized contractors using trained applicators and applied in accordance to the product specification, will perform as stated in the Product Technical Data Sheet.” It runs for the life of the building only if the original purchaser registers with the maker’s warranty department within the period it sets, and it leaves out “defects or failure caused by improper installation of Product”. Another maker’s product may carry different conditions.

Insulation warranty certificate: what paperwork should the customer get?

The FTC’s R-value rule sets the floor for installers of home insulation: show the customer the fact sheet before the customer agrees to buy, then give “a contract or receipt for the insulation you install”, and “The receipt must be dated and signed by the installer.” Beyond that, hand over the manufacturer’s warranty with any registration step it asks of the owner, and your own written workmanship warranty stating its term, what you will do and how to make a claim.

What insurance covers faulty workmanship on a spray foam job?

Liability insurance answers for damages it covers; it is not a promise to fix the work. The ISO form pays sums the business “becomes legally obligated to pay as damages because of ‘bodily injury’ or ‘property damage’ to which this insurance applies.” Exclusion j removes the part that must be redone “because ‘your work’ was incorrectly performed on it”, though not within the products-completed operations hazard, where exclusion l applies, with an exception for a subcontractor’s work. Your policy’s wording decides.

Completed operations coverage: does it pay for a warranty callback?

It answers for injury or damage tied to finished jobs, within the form’s terms, not for the labor of keeping your promise. The ISO form’s hazard takes in injury and damage “occurring away from premises you own or rent and arising out of ‘your product’ or ‘your work’”, and it says “Work that may need service, maintenance, correction, repair or replacement, but which is otherwise complete, will be treated as completed.” A stained ceiling below the foam is a separate question from respraying the foam.

How long does spray foam last under a manufacturer’s warranty?

This guide does not say how long foam lasts in a building; it reports what warranties say about their own term. A closed-cell warranty read here says “This warranty is in effect throughout the life of the building provided the original purchaser registers with the Warranty Department” of the maker within a period it sets. A warranty is a promise with conditions, so a missed registration or an installation outside the maker’s instructions can leave the owner without it.