An additional insured endorsement adds the general contractor or owner to your liability policy for claims tied to your work. In the City of Sierra Madre’s samples, ongoing-operations wording, completed-operations wording, primary and noncontributory wording and the waivers of recovery appear as separate endorsement forms.
What the endorsement adds to your policy
In the City’s samples, an additional insured endorsement changes who counts as an insured on the liability policy, and only for the claims the form describes. The City of Sierra Madre, California, posts sample insurance documents for construction contracts that include additional insured, primary and noncontributory, and waiver endorsements, and they show how the added party gets named.
The automatic-status sample adds “Any person or organization for whom you are performing operations when you and such person or organization have agreed in writing in a contract or agreement that such person or organization be added as an additional insured on your policy”, so in that sample the written agreement does the naming. The scheduled completed-operations sample adds only “the person(s) or organization(s) shown in the Schedule”, so a party who appears nowhere in that schedule or the declarations it points to is not added.
Each sample reaches only the claims it describes. The automatic-status sample reaches the added party where bodily injury, property damage or personal and advertising injury is “caused, in whole or in part, by” your acts or omissions, or by whoever acts on your behalf, in your ongoing operations. The completed-operations sample reaches property damage or bodily injury “caused, in whole or in part, by” your work at the scheduled location that was performed for the scheduled party. The automatic-status sample states that its cover only applies to the extent permitted by law and will not be broader than the contract requires. The completed-operations sample states the same law limit and, where a contract requires the cover, the same contract limit.
Ongoing-operations wording while the job is open
In the City’s automatic-status sample, the added party stands as an insured while your operations for it are under way, and only for the liability that sample describes. That sample says when the status stops: it “ends when your operations for the person or organization” the form describes “are completed”. After that point, the City’s samples place finished work in a completed-operations endorsement that is separate from the automatic-status endorsement.
The added party’s cover carries exclusions of its own. The sample says that “With respect to the insurance afforded to these additional insureds” the form adds exclusions, including an exclusion for “any professional architectural, engineering or surveying services”, with “Supervisory, inspection, architectural or engineering activities.” listed among them. In that sample, those exclusions govern the added party’s cover, not the rest of your policy.
Completed-operations wording for finished jobs
In the City’s sample, completed-operations wording follows finished work. Its schedule is headed “Location And Description Of Completed Operations”, and the form adds the scheduled party for liability “caused, in whole or in part, by” your work at the scheduled location that was performed for that party, when that work falls within the hazard the policy calls products-completed operations.
Under the City’s automatic-status sample, the added party’s status has ended once operations for it are completed, and the City’s completed-operations sample is a separate endorsement with its own schedule.
How the policy’s limit for finished work is built is the subject of our post on the products-completed operations aggregate. This post stays with who is added and when.
Primary and noncontributory wording
The NAIC glossary defines primary insurance as “coverage that takes precedence when more than one policy covers the same loss”. The Other Insurance condition in the sample coverage form the County of Sonoma posts says “This insurance is primary except when Paragraph b. below applies.” When other insurance is also primary, the same condition says “we will share with all that other insurance by the method described in Paragraph c. below”, and where any of the other insurance does not permit contribution by equal shares, “we will contribute by limits.”
The City’s sample primary and noncontributory endorsement says “This insurance is primary to and will not seek contribution from any other insurance available to an additional insured under your policy”, provided that each of these provisos is met: the additional insured is a named insured under such other insurance, and you have agreed in writing in a contract or agreement that this insurance would be primary and would not seek contribution.
In the County of Sonoma’s sample coverage form, the Other Insurance condition makes your policy excess over “Any other primary insurance available to you covering liability for damages arising out of the premises or operations, or the products and completed operations, for which you have been added as an additional insured.”
What a waiver of subrogation gives up
Subrogation is an insurance company’s right to recover from a third party at fault for a loss it paid. The NAIC glossary says “Insurer maintains the right to seek reimbursement for losses incurred by insurer at the fault of a third party.” The subrogation condition in the sample coverage form the County of Sonoma posts passes the insured’s recovery rights to the insurance company: “If the insured has rights to recover all or part of any payment we have made under this Coverage Part, those rights are transferred to us. The insured must do nothing after loss to impair them.”
The City’s liability waiver sample is titled “WAIVER OF TRANSFER OF RIGHTS OF RECOVERY AGAINST OTHERS TO US”, and it lists the protected party on a schedule. It waives the right for payments “for injury or damage arising out of your ongoing operations” or your work “done under a contract with that person or organization”, the work limb reaching only work the sample places within the products-completed operations hazard, and only for the party in the schedule.
In the City’s samples, the comp waiver is a separate endorsement from the liability waiver. The sample comp waiver opens “We have the right to recover our payments from anyone liable for an injury covered by this policy.”, then gives that right up for the party it names in its schedule: “We will not enforce our right against the person or organization named in the Schedule.” It limits itself: “This agreement applies only to the extent that you perform work under a written contract that requires you to obtain this agreement from us.” It closes “This agreement shall not operate directly or indirectly to benefit anyone not named in the Schedule.” For the policy built for your own crew, read the workers’ compensation page.
How state law narrows the ask
The City’s automatic-status and completed-operations samples apply the added party’s cover only to the extent the law permits, and Kansas, Colorado and Texas write limits into statute. Each statute below is quoted in its own words.
Kansas has a statute on construction contracts that says “A provision in a contract which requires a party to provide liability coverage to another party, as an additional insured, for such other party’s own negligence or intentional acts or omissions is against public policy and is void and unenforceable.” It defines a construction contract as an agreement for the “design, construction, alteration, renovation, repair or maintenance of a building, structure” and other improvements to real property, and it says the act does not affect “The contractual obligation of a contractor or owner to provide railroad protective insurance or general liability insurance”.
Colorado words its rule differently, in its statute on civil liability and construction agreements, here as shown in the legislature’s published printout of the Colorado statutes, which is marked as uncertified, so check the current official text before relying on the wording. The ban on shifting construction negligence does not apply to “contract provisions that require the indemnitor to name the indemnitee as an additional insured on the indemnitor’s policy of insurance, but only to the extent that such additional insured coverage provides coverage to the indemnitee for liability due to the acts or omissions of the indemnitor.” A provision in a construction agreement that requires additional insured coverage for damage arising out of death, bodily injury or property damage from acts or omissions “not caused by the negligence or fault of the party providing such additional insured coverage” is void as against public policy. The statute defines a construction agreement and lists exclusions, among them agreements that concern property owned or operated by a railroad.
Texas puts its rule in the insurance code chapter on consolidated insurance programs. A construction-contract provision requiring “additional insured coverage, or any coverage endorsement” is “void and unenforceable to the extent that it requires or provides coverage the scope of which is prohibited under this subchapter for an agreement to indemnify, hold harmless, or defend”. The subchapter applies to a construction contract for a construction project for which an indemnitor is provided or procures insurance subject to that chapter or to Title 10. It also carries exceptions. Its indemnity rule does not apply to a provision requiring a person to indemnify another party “against a claim for the bodily injury or death of an employee of the indemnitor, its agent, or its subcontractor of any tier”, and the chapter’s list of what the subchapter does not affect includes an indemnity provision pertaining to “a single family house, townhouse, duplex, or land development directly related thereto” and another pertaining to “a public works project of a municipality”. The additional insured rule opens with “Except as provided by Subsection (b)”, which sets aside certain policy provisions issued under a consolidated insurance program.
Each statute above is quoted for its own state only.
Real-World Scenario: A fiberglass batt crew finishes the wall cavities of a medical office build-out for a general contractor. The subcontract asked for ongoing-operations wording, so the general contractor was an added party while the crew worked, and under the automatic-status wording in the City’s sample that status ends when the crew’s operations for it are completed. Months later a claim about the finished wall cavities reaches the general contractor. What it can look to is the completed-operations endorsement, if the subcontract asked for it and the policy carries it.
Whether the material changes the wording
The City’s sample wording speaks of your operations and your work. Our general liability page covers the policy these endorsements attach to; each material has its own page, fiberglass, blown-in and cellulose and spray foam.
Where these terms sit among a contract’s indemnity, payment and scope clauses is the subject of how to bid insulation jobs.
What to hand your agent before you sign
Send the whole insurance article, not a summary, along with the quote request. Then list:
- each party the subcontract names, spelled as the contract spells it;
- whether each ask is for ongoing operations, completed operations, or each of them;
- whether the contract requires primary and noncontributory wording;
- which policies the waiver of subrogation is requested on: liability, workers’ compensation, or each;
- the job’s state.
The City of Sierra Madre’s sample certificate says “A statement on this certificate does not confer rights to the certificate holder in lieu of such endorsement(s).” so keep the endorsements themselves with the policy. Our post on certificates of insurance for subcontractors covers the certificate side, and the general liability page sets out the policy these endorsements attach to. When the list is ready, request a quote or start from our insulation business insurance overview.